11-1/2 Ligne Movement Holder 7100-111/2 Watchmaker Hand Tool

We turn the body of catalogue number 7100-111 to receive an 11-1/2 ligne watch movement without rocking. It supports the mainplate squarely across the bench block during assembly and adjustment. The caliper sits upright so your tweezers clear the balance and train wheels freely.

Mainplate seat

The recess is cut specifically for the perimeter of an 11-1/2 ligne ebauche. It supports the base plate flat against the inner ledge so downward pressure from a screwdriver does not tip the assembly.

Body profile

The cylindrical exterior gives your fingers broad purchase when turning the movement under the loupe. It rests directly on the bench mat without rocking under hand pressure.

Clearance underneath

The central cavity leaves room below for extended pivots, dial feet, and setting levers. Nothing on the underplate binds against the metal base while you service the top bridge.

Bench placement

Keep the holder clear of brass filings and bench debris by wiping the inner step before seating a bare plate. It stores in a tray compartment between assembly stages.