55-603 6899-S09 Rotating Stand with 9 Ergonomic Screwdrivers with Spare

Nine screwdrivers sit upright in a rotating base next to your movement holder. Each driver carries a plain knurled handle with a freely turning cap, paired with matching spare blades stored in the carousel tubes. The set covers sizes from 0.5 mm up to 2.5 mm for bridge screws, balance cocks, and casing parts.

Carousel base

The weighted stand turns on a central pivot so you can select the correct blade width without hunting across the bench mat. Spare blades sit in tubes below each position.

Plain handle profile

We turn the bodies with a knurled grip and a smooth swivel head. Your index finger rests still on the top while the thumb and forefinger roll the knurling.

Parallel ground blades

Every tip is ground flat to seat square into screw slots across the movement plates. Sizes run in 0.5 mm, 0.6 mm, 0.8 mm, 1.0 mm, 1.2 mm, 1.4 mm, 1.6 mm, 2.0 mm, and 2.5 mm widths.

Replacing worn tips

A side set screw releases the dull blade from the brass collar. Insert a fresh blade from the base compartment and tighten the screw to resume work.