$40.00
2566
Assortment of 3 holders screw contents 0.30 - 0.40 - 0.50mm
These three holders secure very fine screws by their threads across 0.30mm, 0.40mm, and 0.50mm diameters on the bench.
$235.00
Prices are as the listing last showed them.
| Reference | 2566 |
|---|---|
| Drawer | Holders & Vices |
| What it is | Something that holds the work |
| Bench job | Setting up the bench |
Small screws roll away or bind under a file when held in bare tweezers. We cut these three holders to receive diameters of 0.30mm, 0.40mm, and 0.50mm along their threaded sections. Work sits square while you shorten a shank or dress a head. Catalogue 2566 keeps the trio together for the bench.
Threaded bore fit
Each holder takes a specific screw diameter so the thread walls seat without crushing the pitch. You thread the piece in until the head registers flat against the face.
Body and grip
The outer stock is turned for steady handling with fingers or a small hand vice. It provides enough surface to hold the work true while you dress the exposed end.
Three distinct diameters
The set covers 0.30mm, 0.40mm, and 0.50mm sizes. Having individual tools for each diameter avoids running fine threads into an oversized or mismatched tapped hole.
Bench storage
The holders keep together near the filing block or the staking tool. Keep the tapped ends clear of swarf with a pegwood point before threading in the next screw.
Alongside it in Holders & Vices
$42.50
$44.99
$125.00
A note that touches this tool
Opening a stubborn case back
Snap backs against screw backs against monobloc cases, how a case key and its dies engage a fluted rim, why the case is held in a holder rather than in the hand, and what to do when the back has been opened badly before.
2566
$235.00