red Watch Hand Fitting Stake for Hands Ø2.10 x 1.20mm

Setting a hand square requires a flat face that clears the center arbor while bearing fully on the pipe. We turn this stake for hand fitting with a 1.20 mm bore. It gives the bench worker direct feel over the downward push.

Bore profile

The center of the face is drilled to 1.20 mm so the stake sits over the pivot without binding. The flat rim delivers steady pressure directly to the hand boss.

Color band

A red band marks this stake for rapid selection at the bench. When several runners sit on the rack, you can confirm the bore size before bringing the tool down.

Direct feel

Held in the fingers or mounted in the press, this runner transmits the resistance of the hand pipe clearly. You feel when the hand seats against its shoulder.

Tool care

Keep the bore clear of dried oil and brass filings. A pegwood point dipped in solvent cleans the recess before you bring the stake over an open dial.