7404-EP

Replacement tip for Setting Hands

This replacement tip fits our 7404 hand setting tool, providing a fresh working face when an original synthetic point wears down.

$15.99

Prices are as the listing last showed them.

Reference	7404-EP
Reference line	7404
Drawer	Hands & Movement Work
What it is	A tool in its own right
Bench job	Fitting hands

Hand setting tools take steady downward pressure directly over dial pivots and hand bosses. When the working end of a tool in our 7404 family becomes grooved or burred through long service, we supply this individual replacement point. It seats directly into the tool holder so the hand setter returns to bench work without delay.

Synthetic working face

The tip presents a non-marring synthetic surface directly against the hand pipe. It transfers downward pressure from the handle while the tool seats the hand over its pinion.

Seating in the holder

We turn the shank to fit the collet of the 7404 hand setting tool. It locks into the tool body so there is no wobble as you steady the tool over the center wheel pivot.

Replacing a worn point

Tips eventually pick up debris or lose their flat face after repeated use on tight hand bosses. You loosen the holder, pull the spent point, and press this piece into place.

Bench storage

Keep spare tips in a small compartment box away from loose metal tools. Grit embedded in the synthetic end will transfer to watch hands if left unprotected on the bench mat.