Screwdriver 2.50mm Swiss Made

We size this 30080-09 driver with a 2.5 mm blade for heavier casing screws, bridge fastenings, and rotor posts. The knurled barrel gives your fingers purchase while the swivel cap turns freely under the index tip. You dress or change the flat blade when worn.

Blade width and profile

We grind the blade parallel at the tip to seat deep in a 2.5 mm screw slot. The flat faces bear squarely against the slot walls rather than wedging against the top edges.

Knurled barrel grip

Fine diamond knurling runs along the body where the thumb and middle finger rest. It provides steady purchase when you back out a stubborn movement foot screw or tighten a case clamp.

Swivel cap action

The head rotates freely on the top of the barrel. Your index finger rests on the cap to apply downward pressure while your other fingers turn the stem beneath it.

Replacing the tip

A single set screw in the side of the ferrule locks the blade into the body. Back it off with a smaller driver, pull the worn steel, and seat a fresh 2.5 mm point.